회의용 마이크 시스템DCen MkII (중앙 제어 장치) upgrade

DIGIMIC DCen MkII

Central Control Unit with 32 Audio Channels

DCen 제어장치는 DIGIMIC 마이크 및 통역시스템 내의 모든 유닛에 전원을 공급하여 자동으로 시스템을 구성하고 디지털 오디오를 필요한 곳에 정확하게 라우팅합니다. DCen은 자동모드, 대화 및 발언요청, 투표(CMic 콘솔), 의장 우선순위 및 VIP 관리를 포함한 모든 공통적인 마이크 모드를 관리하고 제어하며, DDol 타입의 통역콘솔을 관리하고 제어합니다. 

새로운 DCen은 4개의 RJ45 단자를 제공하여 최대100개까지의 개별 회의장치를 연결할 수 있으며, 각 출력에는 독립된 전원이 공급됩니다. 따라서 만약 한 개 라인에서 문제가 발생하더라도 다른 출력은 문제없이 계속 동작합니다. DDol 통역콘솔 또한 DCen에서 직접 컨트롤 할 수 있으며, 한 개의 중앙 장치로 최대 32개 언어까지 가능한 마이크 & 통역시스템을 제공합니다.


장치가 중앙제어장치에 연결이 되면 추가 설정없이 바로 사용이 가능합니다. 무료로 제공되는 DCen 구성도구를 사용하여 커스터마이징을 할 수도 있습니다. DCen을 이더넷으로 연결하여, 통합 회의관리 소프트웨어인 BrahlerOS로 마이크 제어, 이름 관리, 접근 제어 그리고 투표 등을 터치스크린 또는 PC를 통하여 손쉽게 실행할 수 있습니다.

다른 장치에 쉽게 연결할 수 있도록 DCen에는 1개의 아날로그 입력과 5개의 아날로그 출력이 장착되어 있습니다. 이러한 밸런스 연결은, Phoenix 터미널로 설계되어 있어 빠르고 쉽게 설치할 수 있습니다.

오디오 매트릭스는 내부컨트롤이 가능하여 여러 마이크와 통역신호를 다른 출력으로 자유로이 라우팅할 수 있습니다. 각 마이크 콘솔은 그룹별로 오디오신호를 독립적으로 사용할 수 있습니다.


Dante™: Easy connection to additional DCens as well as third-party audio devices

In addition, the DCen has a Dante audio interface for connection to further DIGIMIC DCen control consoles or to third-party digital audio systems.

The Dante audio interface provides all 32 translation channels in high quality and is thus perfectly adapted to the needs of a multi-channel simultaneous interpreting system. The routing and distribution of the interpreted languages greatly reduces installation effort.

With its Dante interface, DCen32 integrates easily with Audinate's Digital Media Networking solution. With the integrated 4-port network switch, up to 4 DCens can be connected via Dante without additional hardware. Alternatively, the 4 ports can be set to provide a secondary or primary network, and it also works with hundreds of third-party devices for digital audio processing and connectivity.


Technical Data 

Digital Audio 

  • 48 kHz sample rate 
  • 20 – 20,000 Hz frequency response 
  • Approx. 1 ms latency time 

Audio device interfaces 

  • One analog input (IN) balanced, Phoenix terminal block 
  • Five analog outputs: 1 master +4 x OUT, signals configurable via audio matrix, connection: Phoenix terminal block 

Dante™ Interface 

Configurable Ethernet switch for 4 Dante ports

  • Configurable via Dante controller as primary/secondary or as 4-port switch
  • Link Speed: 1 Gbps 
  • Sample Rate: 48 kBps/24 bit
  • Number of DANTE input channels: 48 (32 languages + 16 input channels (floor mix))
  • Number of output channels: 64 (32 languages + 32 configurable channels)

Controls 

Network connection (TCP/IP) for control by brählerOS software, MicControl software, media control

Connection of units 

  • UNITS L1 ... L4 (RJ45 socket)
  • Min. 25 delegate units on each of the four line outputs depending on cable length
  • Extension of line outputs by means of DExt additional power supply unit

Other connections 

  • USB-A for power supply of external additional devices


Features 

  • 4 independent power supplies - one for each line output. Thus, multiple redundancy in case of failure of one power supply, because the central unit and the other units continue to run undisturbed.
  • HOT SWAP functionality. When a faulty delegate or interpreter unit is replaced, the new unit is automatically configured correctly. Replacement units therefore do not need to be separately preconfigured.
  • Dante™ multi-channel networked audio 
  • 4 green LEDs for indicating the operating voltage at the line outputs
  • 4 red LEDs for indication of voltage failures
  • 4 yellow LEDs to indicate the audio level
  • Info LED for operation display
  • LAN LED for network activity
  • 8 x 32 audio matrix allows sophisticated sound reinforcement support and audio distribution
  • Line outputs protected against short circuit and overload
  • Expandable up to 1000 delegate units

Microphone Modes 

  • AUTomatic – each participant switches itself on/off, optionally with or without limitation of active microphones 
  • AUTomatic – NEXT/FLOAT - Each participant switches itself on/off with FIFO function
  • MANual – Manual operation with request-to-speak list
  • PRIOrity – Priority function for chairmen, optionally via microphone button or separate priority button
  • VOX – Automatic activation when speaking

Simultaneous interpretation 

  • Connection of DDol interpreter consoles for translations with up to 32 channels

Power Supply 

  • Mains power: (90 ... 240) AC voltage, (50 ... 60) Hz
  • Power consumption: 480 W max.